Case Jonsbo MOD1 Blade-Green

6,500,000

Specifications

Case Type XL-ATX, ATX, M-AT, Mini-ITX
3.5 inch drive bay internal 4 x
2,5″ inch drive bay internal 5 x
Gehäuselüfter (Front) opt. 3 x 120 mm
Gehäuselüfter (Rückseite) opt. 1 x 120 mm
Case fan (top) opt. 3 x 120 mm
Case fan (bottom) opt. 3 x 120 mm
Height x Width x Depth 505 x 250 x 638 mm
Weight 13,5 kg
Material aluminium, tempered glass
Maximum height of CPU coolers 175 mm
Maximum VGA Card Length 400 mm
Code 4250140355300
Manufacturer number JB MOD1 R
Category: Tag:

Description

mod1_big

MOD1

The Jonsbo MOD1 case convinces users with its innovative open design. Wide customer surveys were taken in for the development of the MOD1, especially water cooling users were asked about their wishes. With the MOD1 Jonsbo created a truly impressive platform for water cooling.

The rugged exterior is highlighted with visually appealing green color elements, while it also emphasizing the high quality materials which have been processed in MOD1. The extravagant and remarkable design automatically draw attention to itself. A clearly visible highlight is the design of the extending aluminium panels and the tempered glass, which not only allow a look at the inner workings, but also ensure a constant supply of fresh air into the interior of the case. One advantage of this type: If additional fans will be installed, they can achieve a better optimum cooling for the whole system.

The chassis of the MOD1 is made of high quality 3.0 mm thick anodized aluminum. The side and top panels instead are made of 5 mm tempered glass, which give the case an impressive stability.

But not only is the exterior kept especially noticeable, the interior is certainly no less exciting. The power supply is installed in the specially designed frame behind the front panel – an extensive cable management system permits a clean installation of the cable. The power connector is located at its usual place at the rear of the case; a corresponding loop cable of the current is pre-installed.

Below the power supply there are also mountings for the hard drives. Four individually removable HDD slide can be used to install hard drives. On the top there can be installed the 3.5” drives. A special highlight of the MOD1 is the ability to use simultaneously 2.5” SSDs, which are screwed on the bottom. Another mounting place can be found under the bottom of the case, which takes a SSD.

The ventilation system of the MOD1 can be optimized through additionally fans. To achieve a better cooling effect, the top can take 3 x 120 mm fans. At the back of the case are mounting options for 1 x 120 mm fan. On the bottom of the case can be installed 3 x 120 mm fan. Behind the front panel are also mounting positions for 3 x 120 mm fans.

The MOD1 also supports 3 x 360 mm water cooling systems, which can be installed in the top or on the bottom of the case. A third one on the partition wall of the motherboard chamber and drive bay. Please check first that there will be no complications with the mainboard, before you build in such a radiator.

Two USB 3.0 and two USB 2.0 connectors are available externally. Thus, external hard disk or USB drives can be connected quickly and easily.

In addition, the MOD1 is equipped with an innovatively lighted Jonsbo badge.

Depicted hardware is not included.

Reviews

There are no reviews yet.

Be the first to review “Case Jonsbo MOD1 Blade-Green”

Your email address will not be published. Required fields are marked *